Surface morphology of composite cobalt − graphite electrodeposite coatings

Authors

  • V. I. Ovcharenko State Higher Education Establishment “Ukrainian State University of Chemical Technology”, Ukraine
  • D. G. Korolyanchuk State Higher Education Establishment “Ukrainian State University of Chemical Technology”, Ukraine

Keywords:

cobalt, graphite, electrodeposition, coating, surface morphology

Abstract

Formulation of the problem. Study of the effect of the electrodeposition regime, geometry and size of graphite particles used as a filler in cobalt deposits on surface morphology of a composite 3…15 μm thick cobalt − graphite electrolytic coating. The surface morphology of a composite 3…15 μm thick cobalt − graphite electrolytic coating was studied. Findings. The influence of the deposition regime, geometry and particle size of graphite on surface morphology of a composite 3…15 μm thick cobalt − graphite electrolytic coating is revealed. It is established that to obtain cobalt − graphite composite electrolytic coatings with a continuous layer of cobalt deposits, it is necessary to use graphite, which is pre-applied by an electrocontact method on the substrate before electrodeposition and also particles being formed as a result of destruction of the graphite anode during electrolysis. Originality. The effect of the deposition regime, geometry and size of graphite particles on surface morphology of composite cobalt − graphite electrolytic coatings is discussed. Practical value. The results of the investigations make it possible to obtain a composite 3…15 μm thick cobalt − graphite electrolytic coating with a continuous layer of cobalt deposits.

Author Biographies

V. I. Ovcharenko, State Higher Education Establishment “Ukrainian State University of Chemical Technology”

Department of Materials Science, Cand. Sc. (Tech.), Ass. Prof.

D. G. Korolyanchuk, State Higher Education Establishment “Ukrainian State University of Chemical Technology”

Department of Materials Science, Ress. Ass.

References

Наумов Л. В. Закономерности электроосаждения сплава кобальт – никель при различных режимах электролиза / Л. В. Наумов // Известия высших учебных заведений. Поволжский регион. Технические науки. – 2013. – № 1 (25). – С. 76–84.

Гальванотехника : справочник / [Ф. Ф. Ажогин, М. А. Беленький, И. Е. Галль и др.]. – Москва : Металлургия, 1987. – 736 с.

Сайфуллин Р. С. Композиционные покрытия и материалы : монография / Р. С. Сайфуллин. – Москва : Химия, 1977. – 272 с.

Королянчук Д. Г. Композиционные электролитические покрытия на основе меди с углеродными наноматериалами / Д. Г. Королянчук, В. Г. Нефёдов, М. Р. Букатина, М. П. Щебельская, В. Д. Захаров, В. Е. Ваганов. – Харьков : НТУ ХПI. – 2015. – № 30 (1139). – С. 51−59.

Электронная микроскопия в металловедении : справочник / [А. В. Смирнова, Г. А. Кокорин, С. М. Полонская и др.]. – Москва : Металлургия, 1985. – 192 с.

Кристаллография, рентгенография и электронная микроскопия : монография / [Я. С. Уманский, Ю. А. Скаков, А. Н. Иванов, Л. Н. Расторгуев]. – Москва : Металлургия, 1982. – 632 с.

Published

2017-11-03