Research the causes of destruction of stainless steel pipes in the boiler ammonia production at PJSC "Dniproazot"

Authors

  • T. А. Derguch State Higher Education Establishment “Pridneprovs’k State Academy of Civil Engineering and Architecture”, Ukraine

Keywords:

stainless steel, hard-wrought pipes, steel 03Х18Н11, structural heterogeneity, standards 5632 and 9941

Abstract

It is set complex researches, that by reason of premature death immersion heater in the vehicle of production of ammonia on the enterprise of "Dneprazot" there is a corrosive damage of outward surface of hard-wrought pipes from steel 03Х18Н11, conditioned by their unsatisfactory quality: structural heterogeneity was become, superficial by a satiation a carbon of pipes, by disparity of their chemical composition and firmness to МКК to the requirements to the standards 5632 and 9941.

Author Biography

T. А. Derguch, State Higher Education Establishment “Pridneprovs’k State Academy of Civil Engineering and Architecture”

Department of Material Science and Treatment of Materials, Leading Researcher

References

Ульянин Е. Москва, 1980. – 208 с.

Туфанов Д. Г. Коррозионная стойкость нержавеющих сталей и чистых металлов / Д. Г. Туфанов // Справочник. – Москва, 1973. – 519 с.

Дергач Т. А., Дейнеко Л. Н. Влияние технологических факторов на структуру и стойкость против МКК труб из низкоуглеродистой аустенитной стали / Т. А. Дергач, Л. Н. Дейнеко // Металлургическая и горнорудная промышленность. – 2003. – № 6. – С. 57–61.

Downloads

Published

2014-05-10

Issue

No. 2 (2014): Metal Science and Heat Treatment of Metals

Section

Technical science

License

Authors that are published in this journal agree to follow the conditions:

Authors reserve the right to the authorship of his work and cede the right to the journal of first publication of this work on conditions of the license under the Creative Commons Attribution License, which allows others to distribute it freely with the obligatory reference to the author of the original work and the first publication of the work in this journal.